Applies to: E5

Spare parts and wear parts

Definition of wear parts

Wear parts necessarily wear out or fail during use. They must be replaced within the time intervals specified in the table below. Use these values to determine operating costs, to plan your spare part stock as well as to create individual maintenance and service plans.

Spare part list

In the table below you can find the most important spare parts for your machine.

Many included accessories can be ordered as spare parts.
Customer Service has an extended list of all spare parts.

Wear part

Self-exchangeable spare part

Part	Replacement interval or conditions	Description
AirTool insert (E1)	500 operating hours^*	 Exchanging tool magazine inserts and associated holders
Transport securing set Spindle lock Accessories boxes (without accessories) Transport lock left/right	If defective	 Transportation and storage
System module	If defective	 Exchanging the system module
Service cover, bottom	If defective	See  Exchanging the system module
Top service cover	If defective	See  Exchanging the spindle unit
Blank holder	If defective	 Exchanging the blank holder
Power cable	If defective	See  Establishing the electric connection
Measuring key protective cap	If defective	 Exchanging the measuring key protective cap
Measuring key	If defective	 Exchanging the measuring key
Main fuse T6,3A L250V	If defective	 Exchanging the main fuse
Holder for tool magazine insert	If defective	 Exchanging tool magazine inserts and associated holders
Holder for AirTool insert	If defective	 Exchanging tool magazine inserts and associated holders
Transport package	If defective	 Transportation and storage
Fixing latches and clamping blocks for upper and lower service covers	If defective	 Exchanging the fixing latches and clamping blocks on the upper service cover  Exchanging the fixing latches and clamping blocks on the lower service cover
Working chamber door	If defective	 Exchanging the working chamber door
Bit TX20	If defective
Cover cap for fixing screws of the A-B axis module	If defective	See  Exchanging the A-B axis module
Cover cap for opening the emergency release	If defective	See  Emergency opening of the working chamber door
A-B axis module	If defective	 Exchanging the A-B axis module
Torque screwdriver 1.5 Nm	If defective
Tool magazine insert (A1 - D4)	500 operating hours^*	 Exchanging tool magazine inserts and associated holders
Spindle bearings (requires spindle exchange)	2,000 operating hours^*	 Exchanging the spindle unit
Spindle unit SFE 300E	2,000 operating hours^*	 Exchanging the spindle unit
Collet chuck for spindle unit SFE 300E	500 operating hours^*	 Cleaning or exchanging the collet chuck of the spindle
Bellow in the working chamber	1000 operating hours^*	 Exchanging the bellow
Gasket of the working chamber door	If defective	 Exchanging the gasket of the working chamber door
Locking bolt for system module	If defective	 Exchanging the system module locking bolt

*These are recommendation guidelines. Depending on the processing material and how well the machine is cleaned, these values may differ.