Applies to: Z4

Commissioning

Watch the video

YouTube video – When viewing this video, personal data is sent to YouTube, LLC, USA. Privacy statement

The installation steps up to operation are:

→

→

→

Step 1: Removing the transport lock

NOTICE

Short-circuit hazard when the machine is too cold

If the machine is transported from a cold environment into a warmer environment, a short circuit may occur caused by condensate.

  • Before switching on the machine after transportation, ensure the following:
  • The ambient air has the allowed temperature.
  • The machine has the same temperature as the ambient air. This will take at least 48 hours.
  • The machine is completely dry.

Before operating the machine for the first time, you must remove the transport lock in the machine working chamber. The transport lock prevents the spindle from getting damaged during transport.

  1. Ensure the following:
    • The machine is connected to the electrical source.
  2. Switch on the machine at the main power switch.
  3. Machines with internal CAM computerClosed The computer that is connected to your machine and which runs DentalCAM and DentalCNC.: Press the start button.
  4. Machines with external CAM computerClosed The computer that is connected to your machine and which runs DentalCAM and DentalCNC.: Start the CAM computerClosed The computer that is connected to your machine and which runs DentalCAM and DentalCNC..
    • The machine references.
  5. Open the working chamber door by selecting the upper arrow of the depicted icon on the touchscreen.
  6. Remove the transport lock as shown in the supplement.

Step 2: Removing the protective film

At delivery, the following pieces of protective film are attached to the machine:

  • 2 on the front machine housing
  • 1 on the working chamber door
  • 1 on the top cover
  • 4 in the multi-purpose drawer
  • Before machine installation, carefully peel the protective film off the machine with your hands.

Step 3: Checking the tool magazines in the multi-purpose drawer

After you have removed the transport lock, you should open the multi-purpose drawer and check the tool magazines.

  1. To unlock the multi-purpose drawer, select the lower arrow of the depicted icon in the Home section of the touchscreen.
    • After a couple of seconds, the drawer will move slightly forward.
  2. Pull the drawer open.
  3. Remove all pieces of the protective film.
  4. Remove the cover for the transport lock from the tool magazines.
  5. Verify that there are 5 tool magazines with different color codes in the drawer.
  6. To close the multi-purpose drawer, push it until it locks back in place.
    • You will hear a clicking sound.

More information on tool magazines and tool management: Operation