Applies to: S5

Commissioning

The installation steps up to operation are:

Step 1: Removing the transport lock

Before operating the machine for the first time, you must remove the transport lock in the machine working chamber. The transport lock prevents the spindle from getting damaged during transport.

1. Ensure the following:
• The machine is connected to the electrical source.
• The CAM computer The computer that is connected to your machine and which runs DentalCAM and DentalCNC. is not connected to the machine.
2. Switch on the machine at the main power switch.
3. Open the working chamber door.
4. Switch off the machine at the main power switch.
5. Remove the transport lock as shown in the supplement.

Step 2: Connecting the CAM computer

NOTICE! The transport lock must not be installed when you connect the CAM computer The computer that is connected to your machine and which runs DentalCAM and DentalCNC. to the machine.

• If you want to control multiple machines with 1 CAM computer The computer that is connected to your machine and which runs DentalCAM and DentalCNC., use our multi-machine control feature. See the documentation for the manufacturing software.

1. Switch on the machine at the main power switch.
2. Close the working chamber door.
3. Start the CAM computer The computer that is connected to your machine and which runs DentalCAM and DentalCNC..
4. Use the provided USB cable to connect a USB port of the CAM computer The computer that is connected to your machine and which runs DentalCAM and DentalCNC. to the USB port at the connection panel of the machine.

To avoid connecting errors, we highly recommend that you use the USB or Ethernet cable which was provided with the device. Original spare parts are available from customer service.

5. Install the newest version of DentalCAM & DentalCNC that is released for the machine. If you want to control multiple machines with 1 CAM computer The computer that is connected to your machine and which runs DentalCAM and DentalCNC., use our multi-machine control feature. See the documentation for the manufacturing software.
6. To determine the USB port number and connect to the machine, select the depicted icon in the Application settings view in DentalCNC.
• DentalCNC will try to establish a connection to the machine. If this is successful, the application will display the port number next to the icon. The machine references.
7. If the working chamber door was open during the previous step, close it. If the machine does not reference as a result, quit DentalCNC and restart the application.