Applies to: Z4

Exchanging the tool magazine inserts

If tool magazine inserts are worn, you should replace them. New inserts are delivered without holes for the tools. The holes must be drilled into the inserts with the machine.

  • Your machine comes with tool magazine inserts as spare parts and with the drill tool.
  • Additional inserts and drill tools are available via customer service.

Customer service exchanges the tool magazine inserts during preventive maintenance. If required, you can exchange tool magazine inserts yourself and have customer service drill the holes into the inserts via remote maintenance.

You can replace tool magazine inserts as follows:

  1. Contact customer service. They will assist you with drilling the holes into the new inserts. Otherwise, you won't be able to insert tools into the tool magazines.
  2. Remove all tools from the desired magazine.
  3. Remove the screws from the bottom of the tool magazine and put them aside.
  4. Firmly press against the tool magazine insert.
    • The insert moves out of the magazine together with its retainer.

     

  5. Insert the new insert into the magazine together with its retainer. Position the insert with the smooth side pointing forwards so that it forms an even surface with the upper side of the tool magazine.
  6. Insert the screws and screw them down.

    7.  

  7. Follow the instructions you receive from customer service and drill the tool positions in the new inserts.

    8.  

  8. Insert the tools into the correct positions of the magazine. Inserting and exchanging tools
  9. Make sure that the correct tool magazine for the next job is mounted. Attaching and exchanging tool magazines