Applies to: Z4

Connecting the machine and computers to the network

We assume that your computers are not part of a Windows domain. If they are, you must take this into account in the overall computer setup.

Preparation

1. Shut down the machine.

2. Configure the operating system on the CAD computer such that the computer can access the network to which the machine will be connected.

Establishing the connection

Wired network

• Connect the machine and the CAD computer to the local network via Ethernet cables.

  Connect the CAD computer directly to the machine only if no local network is available.

• If a DHCP server is available in the local network, the integrated CAM computer The computer that is connected to your machine and which runs DentalCAM and DentalCNC. will automatically try to obtain an IP address.

• Connect the CAM computer The computer that is connected to your machine and which runs DentalCAM and DentalCNC. and the CAD computer to the local network with Ethernet cables.

  Connect the CAD computer directly to the CAM computer The computer that is connected to your machine and which runs DentalCAM and DentalCNC. only if no local network is available.

• If a DHCP server is available in the local network, the integrated CAM computer The computer that is connected to your machine and which runs DentalCAM and DentalCNC. will automatically try to obtain an IP address.

WiFi network

You must first establish a wired direct connection to configure WiFi access on the CAM computer The computer that is connected to your machine and which runs DentalCAM and DentalCNC..

1. Connect the CAD computer to the Ethernet port of the machine with an Ethernet cable.

2. For the moment, deactivate WiFi access on your CAD computer.

   Otherwise, the CAD computer will not find the CAM computer The computer that is connected to your machine and which runs DentalCAM and DentalCNC..

1. Connect the CAD computer to the Ethernet port on the CAM computer The computer that is connected to your machine and which runs DentalCAM and DentalCNC. with an Ethernet cable.

2. For the moment, deactivate WiFi access on your CAD computer.

   Otherwise, the CAD computer will not find the CAM computer The computer that is connected to your machine and which runs DentalCAM and DentalCNC..

Starting the machine

1. Switch on the machine at the main power switch.
2. Machines with internal CAM computer The computer that is connected to your machine and which runs DentalCAM and DentalCNC.: Press the start button.
3. Machines with external CAM computer The computer that is connected to your machine and which runs DentalCAM and DentalCNC.: Start the CAM computer The computer that is connected to your machine and which runs DentalCAM and DentalCNC..
4. Wait until the machine has referenced.