Applies to: E4

Loosening a stuck tool magazine

 

Watch the video

YouTube video – When viewing this video, personal data is sent to YouTube, LLC, USA. Privacy statement

If you can no longer pull the tool magazine from the holder:

  1. Have ready:

    • 1 x Cylinder screw M4 x 30

    • 1 x Angle screwdriver TX 20

    • 1 x Cover cap

  2. Open the working chamber door.

  3. Use a pointed tool to remove the cover cap and put the cap aside within reach.

     

     

  4. Screw in the cylinder head screw with the angle screwdriver.

    • The tool magazine is released.

  5. Pull the tool magazine off the tool magazine holder.

     

     

  6. Use the angle screwdriver to loosen the cylinder head screw and remove it.

  7. Cover the screw opening with the cover cap. If the cap is damaged, use a provided spare cap (7.5 mm).

     

     

  8. Clean and grease the tool magazine and the tool magazine holder as described in the instructions for weekly cleaning of the machine.

    Performing the weekly cleaning