Applies to: Z4

Transportation and storage

WARNING

Injuries caused by unsafe transportation

If you transport the machine unsafely, the machine may slip and cause injuries.

Parts that are not properly mounted can fall and injure you and/or become damaged.

Only stack machines that are properly packed and secured against slipping.
Ensure that only trained personnel transport the machine to and from the installation site.
Ensure that the machine housing is completely closed.
Always transport the machine in an upright position.
Transport and position the machine with as many people as required for the weight of the machine in accordance with local and / or national laws and regulations.
Carry unpacked machines only with the carrying aid installed. Make sure that all components are secured. Do not use any other carrying aid.
Grab unpacked machines only at the handles of the carrying aid. Always carry the machine in an upright position.

NOTICE

Machine damage due to improper transport and / or storage

Ensure that all conditions set forth in the chapter are met during the entire transport and / or storage period Technical data.

The supplement about the carrying aid and transport lock is delivered with the machine. They are also available for download here.

Preparing for transportation or storage

Remove all blanks from the working chamber.
Remove the tool magazine from the working chamber.
Rinse the cooling liquid system.
Empty and clean the cooling liquid tank. Ensure that the tank is completely dry.
Clean the working chamber. Ensure that the working chamber is completely dry.
Insert a block into the blank holder.
Install the transport lock. For this, follow the corresponding steps on the attachment.
Ensure that the machine housing is completely closed.
Shut down the machine via the touchscreen.
Switch off the machine via the main power switch.
Disassemble the machine components by following the installation instructions in reverse order.
Machines with an external CAM computer The computer that is connected to your machine and which runs DentalCAM and DentalCNC.: Disassemble the CAM computer The computer that is connected to your machine and which runs DentalCAM and DentalCNC. by following the instructions in the installation manual for the CAM computer The computer that is connected to your machine and which runs DentalCAM and DentalCNC. in reverse order.
If you need to carry the machine, install the carrying aid. For this, follow the corresponding steps on the supplement.
In case of overseas transport, take proper measures against corrosion.

To repack the machine after preparing its transportation or storage, the following steps are necessary:

If possible, use the original packaging. If the original packaging is not available, use a packaging of similar size and quality.

Original packaging is available from customer service.
Pack the machine and its accessories securely. Follow the instructions on the supplement.
Protect the packaging against slipping. If machines are properly packed and protected against slipping, they may be stacked.