Emergency opening of the working chamber door
Cutting injuries caused by rotating tools
If a power failure or a machine malfunction occurs during machining, the spindle including the inserted tool keeps rotating. If you touch the rotating tool, you will suffer from cutting injuries.
- Wait until the spindle has stopped rotating before performing an emergency opening.
- Do not carry out the emergency opening during regular operation.
Due to the safety interlock you can only open the working chamber door when the machine is supplied with power. In the event of a prolonged power failure, use the emergency release to access the working chamber.
Location of the opening for the emergency release:
-
DANGER!Switch off the machine at the main power switch.
-
Disconnect the machine from the eletrical source.
- Open the blank magazine
Part of the blank changer in which you store the blanks for automatic loading. door.
-
-
Insert the key for the emergency release of the working chamber door through the opening.
-
Deactivate the safety interlock of the working chamber door by turning the key counterclockwise by 90°.
-
Open the working chamber door.
-
CAUTION!Wear gloves.
-
Carry out your work in the working chamber.
-
Close the working chamber door.
-
Reactivate the safety interlock of the working chamber door by turning the key for the emergency release clockwise by 90°.
-
Check if the working chamber door is actually locked.
If this is not the case, try once again to lock the working chamber door.
-
If the working chamber door cannot be locked, secure the machine against being switched on again. Contact customer service.
-
WARNING!Danger of crushing and cutting injuries when the working chamber door is unlocked during operation
