Applies to: Wet grinding module

Transportation and storage

WARNING

Injuries caused by unsafe transportation

If you transport the machine unsafely, the machine may slip and cause injuries.

Parts that are not properly mounted can fall and injure you and/or become damaged.

  • Only stack machines that are properly packed and secured against slipping.

  • Ensure that only trained personnel transport the machine to and from the installation site.
  • Ensure that the machine housing is completely closed.
  • Always transport the machine in an upright position.
  • Transport and position the machine with as many people as required for the weight of the machine in accordance with local and / or national laws and regulations.
  • Grip unpacked machines only by the left and right handles at the bottom of the machine. Always carry the machine in an upright position.

  • Always store the machine insert in an upright position, otherwise the support foot may break.

NOTICE

Machine damage due to improper transport and / or storage

  • Ensure that all conditions set forth in the chapter are met during the entire transport and / or storage period Technical data.

Preparing for transportation or storage

  1. Rinse the cooling liquid system.
  2. Empty and clean the cooling liquid tank. Ensure that the tank is completely dry.
  3. Ensure that the machine housing is completely closed.
  4. Switch off the machine via the main power switch.
  5. Disassemble the machine components by following the installation instructions in reverse order.
  6. In case of overseas transport, take proper measures against corrosion.

Packing the machine

To repack the machine after preparing its transportation or storage, the following steps are necessary:

  1. If possible, use the original packaging. If the original packaging is not available, use a packaging of similar size and quality.

    Original packaging is available from customer service.

  2. Pack the machine and its accessories securely. Follow the instructions on the supplement.
  3. Protect the packaging against slipping. If machines are properly packed and protected against slipping, they may be stacked.

Putting the machine back into operation after storage

  • Follow the instructions for installing the machine.

Installation