Release Notes DentalCAM & DentalCNC 8.02

New firmware version added

The following new firmware versions are now included in DentalCNC:

K5, K5+, N4+, R5, S5, Z4 10.86.056

NOTICE! Incorrect machining results due to incorrect firmware version

• Install the most current firmware version for your machine right after updating DentalCAM & DentalCNC.

 Tools P250-F1-35/ P250-F1-40 can be selected again

The optional tools P250-F1-35/ P250-F1-40 were no longer available for machining thermoflexibles.

This behavior has been corrected.

 (N4/N4+/Z4) The automatic detection of drilling ranges has been corrected

Drilling ranges were sought but not detected.

This behavior has been corrected.

 Unwanted bars no longer occur

When creating sinter bars, DentalCAM added unwanted bars to the disc.

This behavior has been corrected.